Electrical Adjustment - Sharp PG-B10S Anleitung

ELECTRICAL ADJUSTMENT

No. Adjusting point Adjusting conditions
1 EEPROM
1. Turn on the power (with the
initialization
2-1 R/G/B Bright- 1. Select the following group
ness adjustment
(Process GAMMA interlock)
2. Feed the SVGA 16-step sig-
2-2 R/G/B Contrast 1. Select the following group
adjustment
(Process GAMMA interlock)
2. Feed the SVGA white sig-
3 DTV Brightness/ 1. Feed a 480P component
Contrast adjust-
ment
2. Select the following group
(Process GAMMA interlock)
4 DVD Brightness/ 1. Feed a 480I component 10-
Contrast adjust-
ment
2. Select the following group
(Process GAMMA interlock)
lamp on) and warm up the
set for 15 minutes.
and subjects.
Group : AD
Subject : R-Bright
G-Bright
B-Bright
nal with an amplitude level
of 50% (0.35 Vp-p).
and subjects.
Group : AD
Subject : R-Contrast
G-Contrast
B-Contrast
nal with an amplitude level
of 96% (0.67 Vp-p).
10-step signal with 100%
amplitude.
and subjects.
Group : DTV
Subject : Bright
Contrast
step signal with 100%
amplitude.
and subjects.
Group : DVD
Subject : Bright
Contrast
25
Adjusting procedure
» Make the following settings.
Press S2002 to call the process mode and execute
"SS2" on SS menu.
1.Check the setting valve.
R/G/B-Bright: 63
1.Watching the screen, adjust the R-, G- and B-Con-
trast settings so that because of some pixel drop-
outs, the bright color zone should become just about
a half.
1. Check the setting value.
Contrast (White Level): 45
Bright (Black Level): 32
1. Check the setting value.
Contrast (White Level): 46
Bright (Black Level): 34
PG-B10S