Sharp PG-B10S Anleitung Seite 29

No. No. Adjusting point Adjusting point Adjusting conditions Adjusting conditions
21 Sample hold 1. Feed the SVGA 75-Hz
pulse phase
checking 2. Select the following group
22 RGB tone 1. Feed the SMPTE pattern
reproduction
adjustment
23 White balance 1. Use the adjustment condi-
checking
24 Off-timer per-
formance
25 Thermistor 1. Heat the thermistor with a
performance
checking
26 Auto sync 1. Feed the phase check pat-
performance
checking
27 Delivery set-
tings
black signal.
and subjects.
Group : OUTPUT3
Subject : GCK-PHASE
RCK-PHASE
BCK-PHASE
signal.
tions in the item 10 for RGB
input and item 11 for sRGB
input.
hair dryer.
tern signal.
29
Adjusting procedure Adjusting procedure
1. Check the fixed value.
GCK-PHASE :282
RCK-PHASE :282
BCK-PHASE :282
1. Make sure the 100% and 95% white as well as the
0% and 5% black gradations are visible.
Check that there is no deviation of white balance with
the monitor.
1. Select OFF from the process mode.
Make sure the off-timer starts with 5 minutes
onscreen and count one minute in one second.
And then indication is 0 minute, the power supply
of the set is cut off.
1. Make sure that the temperature is indicated.
1. In the VGA, SVGA and XGA modes, make sure the
Clock, Phase, H-Pos and V-Pos settings can be au-
tomatically adjusted.
1. Make the following settings.
Process adjustment Remote control adjustment
SS3 Factory setting at 3
PG-B10S