Sharp PG-B10S Anleitung Seite 27

No. Adjusting point Adjusting conditions
8 Panel ghost 1. Get the SVGA60Hz ghost
adjustment
2. Sample hold pulse phase
3. ENBX width adjustment
4. ENBXR phase adjustment
5. ENBXG phase adjustment
6. ENBXB phase adjustment
9 RGB 1. Feed the counter voltage
countervoltage
adjustment 2. Select the following group
10 RGB white 1. Feed the RGB 50% gray
balance adjust-
ment 2. Select the following group
11 sRGB adjust- 1. Feed the RGB 50% gray
ment
2. Select the following group
test pattern on the project
s c r e e n ( t h i c k b l a c k
c h a r a c t e r s o n R G B
halftone background).
Group: OUTPUT3
adjustment
M a ke s u r e t h e R C K -
PHASE setting is 282
(initial value).
M a ke s u r e t h e G C K -
PHASE setting is 282
(initial value).
M a k e s u r e t h e B C K -
PHASE setting is 282
(initial value).
Make sure this setting is
the fixed value of 4 (initial
value).
(R-LCD ghost adjustment)
(G-LCD ghost adjustment)
(B-LCD ghost adjustment)
Make sure these three
settings are all the initial
value of 13.
adjustment signal. (SVGA)
and subjects.
Group : OUTPUT3
Subject : RC
GC
BC
signal. (SVGA)
and subjects.
Group : OUTPUT1
Subject : R1-BLK(R)
B1-BLK(B)
signal. (SVGA)
and subjects.
Group : OUTPUT1
Subject : S-R1-BLK
S-B1-BLK
27
Adjusting procedure
1. E N B X R p h a s e a d j u s t m e n t ( R - L C D g h o s t
adjustment)
Increase the setting until the ghost (Note) becomes
visible on the left of the black characters on the R
halftone background.
Decrease the setting by 1 point until the above ghost
disappears.
Lower the setting by another 1 point.
2. ENBXG phase adjustment (G-LCD ghost adjustment)
Take the steps as 1 above on the G halftone
background.
3. ENBXB phase adjustment (B-LCD ghost adjustment)
Take the steps as 1 above on the B halftone
background.
Note: Left-hand ghost ÅcA faint duplicate image of
characters or the like seen 12 dots leftward on a
screen
Reference: The above adjustments are needed
because the EPSON panels may have 1- or 2-point
deviation between the LCD lot productions.
1. Using the remote controller's button, adjust the
setting so that the flickering be minimum.
2. Adjust the setting so that the image comes to the
center of the screen.
1. Adjust the R1-BLK and B1-BLK(B) settings so that
the chromaticity based on CL200 becomes as
follows (8500K). x=290±5 y=325±5
1. Adjust the R1-BLK and B1-BLK(B) settings so that
the chromaticity based on CL200 becomes as
follows (6500K). x=313±5 y=334±5
PG-B10S