Camille Bauer KINAX HW730 Betriebsanleitung Seite 18

10. Programming instruction
10.1 Control panel
The transmitter is programma-
ble via switch and push-button.
These will be visible after ope-
ning the top cover.
Pressure-time for
programming:
short = 0.1s
long = 1s
Programming within EX Zones 1 and 2 is
permitted, but not in EX Zones 21 and 22.
10.2 Programming "Linear curve"
1. Turn the switch to the linear mode (DIP2 „off")
2. Choose rotary sense:
3. Programming mode „on"
3 x short „0%" (0%; 0%; 0% → LED lights permanently)
4. Bring transmitter to the starting position
Programming 0%
1 x short „0%" (0% → LED flashes shortly 1 x)
5. Bring transmitter to the end position
Programming 100%
1 x short „100%" (100% → LED flashes shortly 1 x)
6. Programming mode „off"
3 x short „0%" ( → LED lights are no longer)
The zeropoint of a factory programmed linear curve can be
shifted, if point 1-4 and 6 of the programming instruction
programming "linear curve" are followed.
If there is in programming mode for about 15 minutes no
button pressed, the programming mode will be closed au-
tomatically without saving the changed parameters.
10.3 Programming "V-characteristic"
I
out
vmax1
20 mA
4 mA
vmin1 vmin2
Rotation clockwise
It is important to note that the points vmax1, vmin1, vmin2,
vmax2 has to turn clockwise!
18
DIP1 „off"; Clockwise
DIP1 „on"; Counterclockwise
vmax2
Angular
position
Operating Instructions HW730 Be
1. Turn the switch to the linear mode (DIP2 „on")
2. Programming mode „on"
3 x short „0%" (0%; 0%; 0% → LED lights permanent-
ly)
3. Bring transmitter in position „vmax1" of the V-cha-
racteristic
Programming vmax1
1 x short „100%" (100% → LED flashes shortly 1 x)
4. Bring transmitter in position „vmin1"
Programming vmin1
1 x short „0%" (0% → LED flashes shortly 1 x)
5. Bring transmitter in position „vmin2" of the V-characte-
ristic
Programming vmin2
1 x long „0%" (0% → LED flashes shortly 2 x)
6. Bring transmitter in position „vmax2"
Programming vmax2
1 x long „100%" (100% → LED flashes shortly 2 x)
7. Programming mode „off"
3 x short „0%" (→ LED lights are no longer)
The zeropoint of a factory programmed V-characteristic can
be shifted, if point 1-3 and 7 of the programming instruction
programming "V-characteristic" are followed.
If there is in programming mode for about 15 minutes no
button pressed, the programming mode will be closed au-
tomatically without saving the changed parameters!
10.4 Restoring the factory default setting (Reset)
8. Programming mode „on"
3 x short „0%" (0%; 0%; 0% → LED lights permanently)
9. Push button „0%" for at least 5 s
(0% → LED flashes shortly 5 x; transmitter restart)
Camille Bauer