Herunterladen Inhalt Inhalt Diese Seite drucken

Sicherheitshinweise - PeakTech 3410 DMM Bedienungsanleitung

Inhaltsverzeichnis

Werbung

1. Sicherheitshinweise

Dieses
Gerät
erfüllt
die
(elektromagnetische
Kompatibilität)
(Niederspannung) entsprechend der Festlegung im Nachtrag
2004/22/EG (CE-Zeichen), Überspannungskategorie III 1000V;
Überspannungskategorie IV 600V; Verschmutzungsgrad 2.
CAT I:
Signalebene, Telekommunikation, elektronische Geräte mit
geringen transienten Überspannungen
CAT II:
Für Hausgeräte, Netzsteckdosen, portable Instrumente etc.
CAT III: Versorgung durch ein unterirdisches Kabel; Festinstallierte
Schalter, Sicherungsautomaten, Steckdosen oder Schütze
CAT IV: Geräte und Einrichtungen, welche z.B. über Freileitungen
versorgt
werden
Blitzbeeinflussung ausgesetzt sind. Hierunter fallen z.B.
Hauptschalter am Stromeingang, Überspannungsableiter,
Stromverbrauchszähler und Rundsteuerempfänger.
Zur Betriebssicherheit des Gerätes und zur Vermeidung von
schweren Verletzungen durch Strom- oder Spannungsüberschläge
bzw. Kurzschlüsse sind nachfolgend aufgeführte Sicherheitshinweise
zum Betrieb des Gerätes unbedingt zu beachten.
Schäden, die durch Nichtbeachtung dieser Hinweise entstehen, sind
von Ansprüchen jeglicher Art ausgeschlossen.
*
Dieses Gerät darf nicht in hochenergetischen Schaltungen
verwendet werden.
*
Gerät nicht auf feuchten oder nassen Untergrund stellen.
*
Gerät nicht in der Nähe starker magnetischer Felder (Motoren,
Transformatoren usw.) betreiben
*
maximal zulässige Eingangsspannung von 1000V AC/DC nicht
überschreiten.
EU-Bestimmungen
2004/108/EG
und
2006/95/EG
und
damit
einer
stärkeren
-1-
Statutory Notification about the Battery Regulations
The delivery of many devices includes batteries, which for example
serve to operate the remote control. There also could be batteries or
accumulators built into the device itself. In connection with the sale of
these batteries or accumulators, we are obliged under the Battery
Regulations to notify our customers of the following:
Please dispose of old batteries at a council collection point or return
them to a local shop at no cost. The disposal in domestic refuse is
strictly forbidden according to the Battery Regulations. You can
return used batteries obtained from us at no charge at the address on
the last side in this manual or by posting with sufficient stamps.
Batteries, which contain harmful substances, are
marked with the symbol of a crossed-out waste bin,
similar to the illustration shown left. Under the waste
bin symbol is the chemical symbol for the harmful
substance, e.g. „Cd" for cadmium, „Pb" stands for
lead and „Hg" for mercury.
You can obtain further information about the Battery Regulations
from
the
Bundesministerium
Reaktorsicherheit
(Federal
Conservation and Reactor Safety).
7.2. Replacing the fuse
WARNING! To avoid electric shock disconnect the test leads before
removing the battery or the fuse. Replace only with the same type of
battery or fuse. Service should be performed only by qualified
personnel.
Caution! For continued protection against fire or other hazard,
replace only with a fuse of the specified voltage and current ratings.
F1 0,63 A / 1000 V F ∅ 10,3 x 38 mm
F2 10 A
/ 1000 V F ∅ 10,3 x 38 mm
für
Umwelt,
Naturschutz
Ministry
of
Environment,
-50-
und
Nature

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis