The Remote Control System; Getting Started - GRAUPNER XG-6i Sport Spec Bedienungsanleitung

FUNCTIONS:
• Digital Steering/Throttle Trim with LED-display
• 2 proportional channels with 1 switch channel (AUX)
• Failsafe
• Steering/Throttle Servo reverse
• Steering Dual rate 20% - 120%
• Transmitter low power indicator with alarm
• Charge socket for transmitter battery
• Rubber steering wheel

THE REMOTE CONTROL SYSTEM

Here you get an overview of the XG-6i Sport Spec 2.4 Ghz 3-channel remote control system
and its various func-tions and settings. Before the fi rst trip should be sure all of these func-
tions and settings have read and understood.
CONTENTS

Getting started............................................................................................................... 1

Binding Process.............................................................................................................. 2
Operating the remote control........................................................................................... 2
Servoreverse.................................................................................................................. 3
Trim Adjustment............................................................................................................. 3
Steering Trim (ST.TRIM)............................................................................................... 3
Throttle Trim (TH.TRIM).............................................................................................. 4
Steering Range (ST.D/R).................................................................................................. 4
Failsafe Function............................................................................................................. 4
GETTING STARTED
1. Place 8 AA batteries in the battery compartment in the bottom of the transmitter. Pay
attention to the polarity! If the batteries are loaded incorrectly, the transmitter may be
damaged.
When the transmitter will not be used for a longer period of time, always remove the
batteries.
2. Connect and install the receiver and servos.
Attention:
The transmitter comes with an Futaba charge socket for the use with Charging-
Cord No. 3022.65! Do not use any other Graupner charging cord, this may destroy
the batteries.
Be careful with the installation of the receiver. Never bend or shorten the coaxial
antenna wire! The actual „antenna" is the stripped end of the antenna wire and
must be installed in the vehicle so far above as possible. Avoid damages of the
antenna cable!
01 94000 GM-Racing XG-6i Sport Spec Instructions
94000-gb.indd Druckbogen 2 von 6 - Seiten (2, 11) 94000-gb.indd Druckbogen 2 von 6 - Seiten (2, 11)
FOR YOUR NOTES:
_________________________________________________
_________________________________________________
_________________________________________________
_________________________________________________
_________________________________________________
_________________________________________________
_________________________________________________
_________________________________________________
_________________________________________________
_________________________________________________
_________________________________________________
_________________________________________________
_________________________________________________
_________________________________________________
_________________________________________________
_________________________________________________
19.01.2009 07:49:19 19.01.2009 07:49:19