Steering Trim (St.trim) - GRAUPNER XG-6i Sport Spec Bedienungsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

SERVOREVERSE (ST./TH.REV)

This function reverses the direction of operation of the servos related to transmitter steering

and throttle. The ST-switch changes the direction of rotation of the Steering servo (channel 1),

the TH-switch those of the Throttle servo (channel 2). NOR means normal direction of rotation

(above), REV changes the direction of rotation (bottom).

TRIMADJUSTMENT

Connect the receiver, servos, and other components and then turn on the power swit-

ches to transmitter and receiver.

Be sure the Steering trim and Throttle trim on the transmitter are at their neutral posi

tion.

When turning on the transmitter, please make sure the transmitter antenna is complete

ly extended. Turn on the transmitter before turning on the receiver, while turn off the

receiver before turning off the transmitter.

STEERING TRIM (ST.TRIM)

Steering neutral adjustments can be made by moving the steering trim knob to the left or the

right.

Racers-Tip: Always check and be sure the servo is at its neutral position before installing a

servo. Adjust the servo horn hole position and linkage so both are parallel. When a servo

saver is used place it as closer to center position as possible. Be sure the steering trim

on the transmitter at the neutral position. Trim Operation And Maximum Trav: Changing the

trim can effect the overall settings, when adjustments are made with the trims, please recheck

your installation for maximum servo travel (ST.D/R).

94000 GM-Racing XG-6i Sport Spec Instructions

94000-gb.indd Druckbogen 4 von 6 - Seiten (4, 9)

FOR YOUR NOTES:

_________________________________________________

19.01.2009 07:49:24

Inhaltsverzeichnis