Throttle Trim (Th.trim); Steering Range (St.d/R); Failsafe Function - GRAUPNER XG-6i Sport Spec Bedienungsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

94000 GM-Racing XG-6i Sport Spec Instructions

94000-gb.indd Druckbogen 5 von 6 - Seiten (8, 5)

THROTTLE TRIM (TH.TRIM)

Throttle neutral adjustments can be made by moving the throttle trim to the left or the

right.

Racers-Tip: When using a electronic speed control, please set the throttle trim to neutral

and make adjustments to the speed control. On a gas powered model, set the trim to neutral

and adjust the linkage to the point where carburetor is fully closed in accordance with the en-

gine instruction manual. Trim Operation and Travel Trim adjustments will effect the overall

servo travel, so please check the (back-ward) movement after the adjustment. When

trim movement is goes to extremes: That means if you make a lot of the trim movement to

get the servo to the neutral position, please recenter the servo horn closer to the neutral

position and inspect your throttle linkage.

1. Press "ST. D/R" key on TX last for 2 seconds, "ST.DR"light on LED panel will be

ﬂ ash-SETUP starts.

2. Press"INC", D/R volume and luminance of "ST.DR" light goes up, "ST. DR" light

turns to be maximum luminance when D/R reaches maximum value.

3. Press"DEC", D/R volume and luminance of "ST.DR" light goes down, "ST. DR"

light turns off when D/R reaches minimum value.

4. Release the key, "ST.DR" ﬂ ashes 3 times, SETUP ﬁ nished.

Note:

Switch on TX by pressing both "INC" and "DEC" botton, TX reset default. All LED ﬂ ash,

reset successfully. TH/ST TRIM return to zero, middle LED on. ST.DR returns to default

volume.

The XG-6i is equipped with a failsafe function. In case of signal loss or empty transmitter

batteries the gas and steering servo will go in neutral position to avoid damage to the

model.

94000 GM-Racing XG-6i Sport Spec Instructions

19.01.2009 07:49:25

Inhaltsverzeichnis