Binding Process; Operating The Remote Control - GRAUPNER XG-6i Sport Spec Bedienungsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

FOR YOUR NOTES:

_________________________________________________

94000-gb.indd Druckbogen 3 von 6 - Seiten (10, 3)

BINDING PROCESS

Switch on TX's power by pressing "Bind Button" on the front side to enter Freqency

Pin setup.

Insert "Pin Jumper" in CH1, then turn on RX's power.

Frequency Pin Setup succeed in if ﬂ ashed RX's LED turn to constant lighting.

Note:

During Frequency Pin Setup, please gather Tx and Rx as close as possible.

Turn on TX before RX.

Once success, no need to process Frequency Pin Setup in each use.

If fail in Setup, please try again patiently.

Remark:

Before to set ID Code, please put the short jack into the ﬁ rst channel (CH1) of the receiver and

then turn on the receiver power, the receiver will into the set ID Code mode.

•

Run your car never with low transmitter or receiver batteries.

If the red Power-LED on the transmitter ﬂ ashes and you hear an alarm

sound, stop running your model an change or recharge batteries!

•

Never forget switch off the radio after running your vehicle , otherwise the batteries do

not last long.

•

Turn on the transmitter ﬁ rst, then the vehicle.

•

After driving ﬁ rst turn off the vehicle, then the transmitter.

•

For optimal use ﬁ rst check the steering and throttle trim positions.

94000 GM-Racing XG-6i Sport Spec Instructions

Bind-Plug

19.01.2009 07:49:19

Inhaltsverzeichnis