Safety Measures - DAB VERTY NOVA 200 Betriebsanleitung

1.SAFETY MEASURES

Before starting the pump, read this instruction booklet carefully.
For safety reasons, the pump must not be used by anyone who has not read these instructions.
The pump must not be used by anyone under 16 years of age; keep children well away from the pump
when in operation.
The power cord and fl oating switch must never be used to carry or move the pump. Always use the
pump's handle.
All contact with water should be avoided while the pump is connected to the electric
power supply.
Protect the plug from humidity. The plug must be accessible when the pump is running.
Never remove the plug by pulling on the power cord.
Before taking any action on the pump, always remove the plug from the power socket.
2. USE
VERTY NOVA 200, VERTY NOVA 400: submersible pumps with integrated fl oat switch specifi cally
designed for uses in narrow pits with dimensions down to 20 cm x 20 cm. Suitable to pump clear water
containing particles with maximum diameter up to 5 mm.
The temperature of the fl uid being pumped must never exceed 35° C
The pump must not be used to pump salt water, sewage (ACI models), fl ammable,
corrosive or explosive liquids (e.g. petroleum oil, petrol, thinners), grease, oils or foodstuffs.
If the power supply cord has been damaged, it must be replaced by the manufacturer or
his authorized customer support service in order to avoid all risks.
Before starting the pump, make sure that:
• the voltage and frequency specifi ed on the pump's nameplate coincide with those of the
available power supply;
• there are no signs of damage to the pump or its power cord;
• the electric connection is made in a dry place, protected against any risk of fl ooding;
• for safety reasons, make sure that the pump is powered via a differential switch the nominal
operating differential current of which does not exceed 30mA and that there is an effective
grounding system.
• the length of the power cord is no more than 10 meters. Any extension cords must
comply with the requirements of the DIN VDE standard 0620.
Note: given the different provisions applicable to the safety of electric systems in different
countries, make sure that the pump system, as concerns its intended use, is in accordance with
current legislation.
4
ENGLISH