D) Generate New Programming Cards - Conrad 61 17 61 Bedienungsanleitung

d) Generate New Programming Cards


This can be required if one or both programming cards are lost or damaged.
• Open the outdoor unit. The sabotage alarm will be activated. End it, e.g. by plugging a small
piece of hard foam, etc. into the switch opening (23) and fastening it there with a strip of
adhesive tape.
• Move the right slide switch (21) up into the position "ON".
• Briefly press the "RESET" button (20). The two LEDs flash alternatingly.
• Hold a card before the sensor area (13) briefly. You will hear a sound signal. This card is now
the programming card "
• Hold a second, different card before the sensor area (13) briefly. You will hear a sound signal
and the red LED flashes quickly. This card is now the programming card "
with a label or waterproof felt pen as well.
• Return the slider (21) to the starting position, push it downwards.
• Briefly press the "RESET" button (20).
• Close the outdoor unit again. Remember to activate the sabotage alarm (remove the hard
foam piece you pushed into the opening of the switch (23)).
• The newly generated programming cards can now be used for adding / programming or
removing / deleting access cards (they cannot be used as access cards!).
+
". Mark the card with a label or waterproof felt pen.
Reset
–
–
+
". Mark the card
39