Calculation Of The Minimum Ballast In The Front With Rear Attachments; Storage; Care And Maintenance; 10.1 General Notes - Kärcher MIC D Bedienungsanleitung

8.2.1.2

Calculation of the minimum ballast in the front with rear attachments

8.2.1.3 Calculation of the minimum ballast in the back with front attachments
8.2.1.4 Calculation of the actual front axle load
8.2.1.5 Calculation of the actual total weight
8.2.1.6 Calculation of the actual rear axle load
9

Storage

WARNING
Risk of personal injury or damage!
Consider the weight of the vehicle when storing it.

If the vehicle is not used for a longer period of time, ob-
serve the following points:
Park the vehicle at a safe, level and dry place.

Turn ignition key to "STOP" and remove it.

10

Care and maintenance

10.1 General notes

Switch off the vehicle and, if necessary, remove the ig-

nition key prior to performing any cleaning or mainte-
nance tasks on the vehicle, replacing parts or switching
over to another function.
The battery must be disconnected prior to working on

the electrical system.
Maintenance work may only be carried out by approved

customer service outlets or experts in this field who are
familiar with the respective safety regulations.
Any welding work on the vehicle or attachments must

be performed by the authorised Kärcher customer ser-
vice.
Working under raised attachments/load beds is dan-

gerous. Only work under raised attachments if they are
mechanically secured (underlaid).
Enter the result in the table.
(Value "x" see details of the manufacturer, if no details, x =
0.45)
Enter the result in the table.
If the required minimum ballast in the front (GV min) is not
reached with the front attachment (GV), the weight of the
front attachment must be increased to the weight of the
minimum ballast in the front!
Enter the actual calculated front axle load and the admis-
sible front axle load stated in the operating instructions of
the work machine into the table.
If the required minimum ballast in the back (GV min) is not
reached with the rear attachment (GH), the weight of the
rear attachment must be increased to the weight of the
minimum ballast in the back!
Secure vehicle against rolling away, lock parking brake.

Change the engine oil and the oil filter.

If frost is expected, check whether there is enough anti-

frosting agent in the cooling water.
Clean the inside and outside of the vehicle.

Turn the main switch to position 0.

If it is stored for more than 1 month, jack up the vehicle.

Charge battery approx. every 2 months.

38
-
EN 95