Cleaning And Replacing The Air Filter - Kärcher MIC D Bedienungsanleitung

10.4.13 Cleaning and replacing the air filter

10.4.14 Replacing the dust filter of the cabin
104
1 Air filter housing
2 Locking
3 Filter cartridge
4 Safety cartridge
Pull out the lock.

Turn the air filter casing in a counter-clockwise direction

and remove it.
Remove the filter cartridge and the safety cartridge.

Clean the interior of the air filter reservoir.

Clean the filter insert: Knock the dust off on a hard sur-

face, do not blow out with compressed air.
Replace the safety cartridge by a new one, do not clean

it.
Check that the sealing surface and the filter insert are

clean and undamaged.
Insert the cleaned filter insert.

Important: A severely contaminated or damaged filter
insert must be replaced.
The fresh air is drawn in through a dust filter or a fine dust
filter (filter class F8 optionally available) at the side of the
B-pillar of the driver cabin.
The replacement should take place every 500 hours, more
often when working in dusty environments.
10.4.14.1 Replacing the dust filter on the outer cabin
1 Cover
2 Dust filter
Unscrew 6 screws of the cover and remove the cover

with the dust filter.
Replace the dust filter in the cover by a new one.

Reattach the cover with the new dust filter.

10.4.14.2 Replacing the dust filter on the inside of the
cabin
1 Clamping lever
2 Cover
3 Dust filter (optional filter class F8)
Open the clamping lever.

Pull up the cover.

Pull out the dust filter and replace by a new one.

Insert new dust filter and reattach the cover.

Note
Check seal and and seating of the filter upon installa-
tion.
47
-
EN