Floating Position (Not With Mdc Variant); Front Power Lift - Kärcher MIC D Bedienungsanleitung

6.2

Floating position (not with MDC variant)

6.2.1 Using the floating position
In order to use the floating position, the main switch float-
ing position must be switched on.
To switch on the floating position function, tap the joy-

stick in the direction of Y2. Then the joystick moves
back to the neutral position.
6.3

Front power lift

3-point or 4-point retainers (option) can be attached to the
front power lift. The relevant attachments can then be fitted
on them.
Certain attachments can also be directly attached to the
front power lift.
ATTENTION
Ensure that the admissible axle load is not exceeded when
fitting attachments on the front power lift.
6.3.1 Operating the front power lift
84
When driving on public roads for transport purposes (not
during cleaning of public roads), the floating position must
be switched off.
The floating position must be switched on or off via the

main switch floating position.
Note
In the floating position, the attachment adapts to the
ground contour.
To switch off the floating position function, pull the joy-

stick in the direction of Y1.
If persons are in the vicinity of the front power lift and fitted
attachments, the front power lift must not be operated.
Ensure that attachments that are fixated on the front power
lift do not touch and damage the vehicle.
To raise the front power lift, pull the joystick in the direc-

tion of Y1.
To lower the front power lift, push the joystick in the di-

rection of Y2.
MDC variant (mechanically controlled drive)
Position control lever
0 Neutral position
1 lower and press down, lever will not lock in
2 lowered, floating position, attachment follows the
floor contour (e.g. brush), lever snaps into place
3 raise, lever will not lock in
4 Forward travel direction
27
-
EN