Electrical Connection; Service Work - Teka VT TC 2P Gebrauchs- Und Montageanweisung

4.3 Electrical connections (connected loads)
(Connected loads and model designation: see front of the operating instructions)
This appliance may only be connected to the electricity supply by an approved electrician who must ensure that
the installation complies with the statutory regulations (Germany VDE, Austria ÖVE, Switzerland SEV, etc.). The
electrician must ensure that these regulations and those laid down by the local electricity supply company are
observed.
When connecting the electrical appliance, install an all-pole disconnecting device with a contact gap of at least
3 mm. Make sure that the local mains voltage is the same as the voltage on the rating label.
In order to connect the hob the cable is connected to a plug box.
See fig. 4 for the position of the cable cut-out.

4.4 Service work

Always disconnect the appliance from the mains before carrying out repairs, this means the cut-out device must
be opened. If you have to contact our service department, always quote the type and make numbers. You can find
these numbers on the rating label or on page 1 of the Operating Instructions. Each time the glass ceramic hob is
removed from the worktop, check the seals and replace if necessary.
224031 19