Operations; Your New Hob; Touch-Control Operations - Teka VT TC 2P Gebrauchs- Und Montageanweisung

1. Operations

1.1 Your new hob with Touch-Control operation
This manual covers the models: .GKST 290 ., FGKST 290 .
1.2 Touch-Control operating panel
After the supply voltage has been applied (mains connection), a self-test of the control unit (calibration adjustment)
is then carried out. Afterwards, the control unit is then in standby mode.
During calibration adjustment a minus sign is lit in the cooking level display
successfully executed.
The touch keys may not be covered by objects or anything else during calibration.

On/off switch (emergency shutdown)

Plus key

Minus key

Cooking level display
Locking key
Lock indicator
Dual-circuit key
Dual-circuit key control lamp

1.3 Touch-Control operations

Each key operation is always confirmed by an acoustic signal.
Pressing the on/off switch key
next action must be carried out within 10 seconds, otherwise the control system will automatically switch off again.

If the minus key is pressed, cooking level 4 is indicated.
Then, a cooking level between 0 and 9 can be selected with the plus or minus key.

The minus key can be used to turn the cooking level down to "0"; if the minus and plus keys
at the same time, the cooking level can be switched off directly.
A "0" appears that goes out after 10 seconds.
In all cases the complete control system can be switched off at any time by pressing the

on/off key .
224031
Dual cooking zone
Griddle

switches on the control system. A "0" is lit for the cooking level indicators

. It goes out if calibration is
Frying zone

 
+ are pressed
. The
13