Description Of The Appliance; Assembly - Kärcher K 7 Premium Bedienungsanleitung

Description of the Appliance

These operating instructions describe the maximum
equipment. Depending on the model, there are differ-
ences in the scopes of delivery (see packaging).
Illustrations on Page 2
1 Water connection with integrated sieve
2 Coupling element for water connection
3 Storage for trigger gun
4 Appliance switch „0/OFF" / „I/ON"
5 High pressure hose
6 Dosage regulator for detergent
7 Storage for trigger gun
8 High-pressure hose drum
9 Transport handle
10 Hand crank for hose drum
11 Storage of Plug 'n' Clean detergent bottle with de-
tergent connection
12 Storage for spray lance
13 Storage hook for mains connection cable
14 Mains cable with mains plug
15 Plug 'n' Clean detergent bottle with locking lid
16 Bearing wheel
17 Trigger gun
18 Lock trigger gun
19 Key to detach the high pressure hose from the trig-
ger gun
20 Spray lance with Dirtblaster
For strong contaminations
21 Spray lance with pressure regulation (Vario Power)
Carrying out the most common cleaning tasks. The
work pressure can be stagelessly regulated be-
tween "SOFT" and "HARD". You can add detergent
when "MIX" is selected.
In order to adjust the working pressure, release the
lever of the trigger gun and turn the spray lance to
the desired position.
** Additionally required
22 Fabric-reinforced water hose with commercially
available coupling.
– Minimum diameter, 1/2 inches (13 mm).
– Minimum length 7.5 m.
Mount loose parts delivered with appliance prior to start-
up.
Illustrations on fold-out pages!
Install the storage for trigger gun
Illustration
 Place the bottom holder into the recesses and push
forward until it audibly locks in.
Illustration
 Insert the top holder and push down all the way.
12

Assembly

Install the storage hook for the mains
Illustration
 Press in the storage hook and lock it into the top po-
sition.
Install the dosage regulator for detergent
You will need the 2 included screws as well as a Phillips
screwdriver PH 2.
Illustration
 Insert both detergent hoses onto the hose fittings.
 Install the dosage regulator and connect using 2
screws.
Note: During installation you must make sure that
the tongues of the dosage regulator match up with
the intended recesses in the casing.
Install the transport handle
Illustration
 Wind up the high-pressure hose on the hose drum.
Illustration
 Slide the free end of the coiled high pressure hose
through the recesses on the dosage regulator.
Illustration
 Attach the transport handle, insert the bolts into the
bores and screw them in.
Illustration
 Press the connecting fitting from the short high
pressure hose into the brass intake until it locks into
place audibly.
Check the secure connection by pulling on the high
pressure hose.
Installing coupling
Illustration
 Screw the coupling element to the water connec-
tion on the appliance.
Connect the high pressure hose to the
Illustration
 Push the high pressure hose into the trigger gun
until it locks audibly.
Note: Make sure the connection nipple is aligned
correctly.
Check the secure connection by pulling on the high
pressure hose.
– 6
EN
connection cable
trigger gun