Automatic Turn And Intermediate Position; Setting The Turn Of The Slats - Selve commeo Receive Connect Betriebsanleitung

Automatic turn/Intermediate position

6. Automatic turn and intermediate position

The following description of the automatic turn and the intermediate
position refers to a blind respectively exterior blind that is connected
to the commeo Receive Connect. The commeo Receive Connect is
preset in the "blind" mode when dispatched.

6.1. Setting the turn of the slats

Operation
> 3 s
Drive
Move the drive to the lower end
position with the DOWN button.
Push the STOP button and then
additionally push the UP button.
Keep both pushed. After 3 seconds,
the programming run starts. Set the
position with the UP and DOWN
buttons while keeping the STOP
button pushed.
Releasing the STOP button will save
the position.
49
GB
GB