Reset The Receiver To The Factory Setting; Configuration Mode (Only For Authorised Qualified Personnel) - Selve commeo Receive Connect Betriebsanleitung

commeo initial operation/Setting
Note for settings under point 4.2.: The motor/receiver must be
selected for this setting with a transmitter in SELECT mode (Status
LED flashes slowly in orange). After completing the setting, the
motor/receiver is still selected (see point 4.).

4.2.4. Reset the receiver to the factory setting

To reset a receiver to factory settings, push the PROG button on the
transmitter for 9 seconds. All settings are reset to factory settings.
There are no transmitters and end positions saved in the motor
anymore! The programmed receiver has been cancelled in the trans-
mitter.
Note:This causes an error message if there are any more
programmed receivers!
If this receiver in operating mode moves over a transmitter
which is still programmed, the transmitter will no longer
9 s
receive a response and will acknowledge this with an error
message.
4.2.5. CONFIGURATION mode (only for authorised qualified per-
sonnel)
To set a receiver to the CONFIGURATION mode, push the STOP and
PROG buttons at the same time for 3 seconds.
+
3 s
Concurrent pushing of the STOP and PROG buttons for 3 seconds
permits leaving the CONFIGURATION mode prematurely.
Note: Only for authorised qualified personnel!
Changes on the configuration adjustment can
lead to a damage of the construction since secu-
rity systems may be switched off.
39
GB
GB