Commeo Initial Operation/Setting; Selection Of A Receiver - Selve commeo Receive Connect Betriebsanleitung

GB

commeo initial operation/Setting

4. commeo initial operation/Setting
commeo initial operation
The commeo initial operation is only possible using commeo trans-
mitters. To complete the settings in the receiver, the receiver must be
selected with a transmitter in SELECT mode. In SELECT mode, there
is only one connection at a time to a receiver. Only this one can be
moved and set.

4.1. Selection of a receiver

By pressing the SELECT button for 3 seconds the transmitter will be
put into the SELECT mode. After the SELECT mode has been star-
ted, the status LED will start to flash quickly and the transmitter will
look for the receiver. The status LED being lit in green indicates that
the receiver has been found and the status LED will flash slowly in
orange. The first receiver completes a brief confirmation run. If no
receivers have been found this will be indicated by the status LED
being lit in red.
Receiver selection with non-programmed transmitter/initial ope-
ration
➧
>1 s
or
Receiver selection with programmed transmitter
1. Select the transmitter channel on which the receiver is
programmed.
2. Push the SELECT button at the transmitter for 3 seconds.
The transmitter is in SELECT mode.
3 s
Note: The receivers found by this method can now be found using
another non-programmed transmitter within 4 minutes. Press the
SELECT button on the additional transmitter for 3 seconds for this
purpose.The transmitter is in SELECT mode. All settings can now be
completed with both transmitters.
1. Interrupt the voltage supply of the recei-
vers for > 1 second. The receivers can be
found within the next 4 minutes.
2. Push the SELECT button at the trans-
3 s
mitter for 3 seconds. The transmitter is in
SELECT mode.
34