Reprogramming If A Transmitter Is Damaged Or Lost; Resetting To The Delivery Status - Selve commeo Receive Connect Betriebsanleitung

GB
iveo initial operation/Setting

5.6. Reprogramming if a transmitter is damaged or lost

Only use if a programmed transmitter is no longer available (damaged
or lost)!
In order to program a new transmitter, the receiver has to be put into
reprogramming mode by disconnecting it from the mains supply.
Subsequently press the PROG button of the new transmitter for
3 sec. All the old transmitters have been deprogrammed.
Fuse
3 s 3 s 3 s

5.7. Resetting to the delivery status

To return the receiver to the state at delivery, the receiver must be
brought into service mode by disconnecting it.Then press the PROG
button of an assigned transmitter for 9 seconds.
The receiver will then have no transmitters or limit positions saved.
Fuse
3 s 3 s 3 s
New transmitter
➧
3 s
Assigned transmitter
➧
3 s
46