Inserting Batteries - VOLTCRAFT WM-500 Bedienungsanleitung

10. INSERTING BATTERIES

• Slide off the protective cap (12) and then remove the moisturizing
cap (11). Remove the moisturizing cap by turning it anticlockwise.
• Remove the cap nut (9) turning it anticlockwise. Carefully remove
the measuring electrode (10) to open the device. The battery
compartment.(8).will.then.be.visible.(see.fig..1).
• Pull the battery compartment lid towards the opposite of the arrow
marking in order to open the battery compartment. The battery
compartment.lid.can.be.flipped.backwards.(see.fig..2).
• Insert 4x 1.5 V type AAA batteries into the battery compartment
observing correct polarity. Observe the polarity markings (+/–) inside
the battery compartment.
• Close the battery compartment lid pulling it slightly in the direction of
the arrow marking, until it locks into place.
• Attach the measuring electrode in such a way, that the recess on the
measuring.electrode.fits.on.the.guide.(see.fig..1.and.fig..2,.top).
Make sure the O ring (sealing ring) does not get damaged or is not
damaged already. If the O ring is damaged, the device is not sealed
anymore and incoming water will damage the electronics.
. Replace.the.O.ring.through.one.of.same.specifications.
• Secure the measuring electrode with the cap nut and turn latter one
clockwise until tight. Do not apply excessive force in order to prevent
damage.
• Then reinstall the moisturizing and protective caps.
• Replace the batteries once the low battery indicator (F) starts
flashing.in.the.display.(4).
20
Fig. 1
Fig. 2