Displays; Inserting Batteries, Battery Change - VOLTCRAFT KBM-100 Bedienungsanleitung

8. DISPLAyS

A Unit
B Measured value
C Calibration mode ("CAL")
D Maximum value ("MAX")
E Battery condition display
F Minimum value ("MIN")
G Data-Hold mode ("HOLD")
H Operating mode
I Temperature unit °C or °F
J Automatic temperature compensation -
("ATC")
K Measured temperature value

9. INSERTING BATTERIES, BATTERy ChANGE

• Open the battery compartment on the top by first turning out the two screws (2) via the
enclosed hexagon socket wrench and then taking off the battery compartment lid (1).
• Insert four type AAA/Micro batteries into the battery compartment in the correct polarity
(observe plus/+ and minus/-). Small symbols next to the battery compartment indicate the
proper alignment of the batteries when inserting.
• Attach the battery casing lid and screw it back on. Observe that the sealing ring in the bat-
tery compartment lid is placed properly.
• The batteries require changing when the display contrast is very weak or the device can no
longer be switched on. For weak batteries, the symbol for the battery condition display (E)
flashes as well.
26
A
B
C
D
E
F
G
H
I
J
K