Mains Connection; Load Connection - AEG Protect B. 500 Betriebsanleitung

6.2

MAINS CONNECTION

Check that the UPS nominal input voltage is compatible with the nominal
voltage that applies in your country. The output voltage preset by the
factory is 230 V AC. You can use the control panel to manually change
this setting to 220 V AC, 230 V AC (default), or 240 V AC at any time.
To ensure that the UPS functions correctly, you must ensure that the
mains cable has an appropriate pre-fuse. All models from the Protect B
range are connected to an standard shockproof socket via the mains
connection cable supplied.
Before connecting the loads to the UPS, leave the UPS connected to
the mains without load for at least six hours. This allows the battery to
charge completely and ensures maximum efficiency.
6.3

LOAD CONNECTION

Before connecting the loads to the UPS, switch the UPS off and discon-
nect it from the mains. Please check that the nominal rating specified
on the nameplate is greater or the same as the total of the load ratings.
Connect the intended loads to the outputs of your UPS. To do so, use
the load connection cable supplied. To begin with, leave your loads
switched off. Please contact your specialist dealer if you require any
additional load connection cables.
Avoid using multi-socket extension cables.
69
EN