Making The Connections; Relay Mode - Omnitronic DJS-2000 Bedienungsanleitung

5

MAKING THE CONNECTIONS

Power cable
Prior to connecting or changing existing connections switch off the player.
1
Set up the unit on a plane, stable ground.
2
Connect subsequent units with line level inputs (e.g. amplifier or mixer) via an RCA cable to the analog
RCA output on the rear. Make sure that the right/left occupation is the same at the devices
3
Use the supplied power cable to connect the player to the mains (100-240 V, 50/60 Hz).

Relay Mode

RCA cable
DJS-2000
With a second DJS-2000, an alternate start of the playback will be possible. For this, connect the jacks
RELAY at both players with the supplied 3.5 mm jack cable and set the fader on the mixer to its center
position. At the end of the title or data carrier (depending on the operating mode selected) playback on the
other player will begin automatically and the first player will enter cue standby mode.
RCA cable
DJS-2000
Mini jack cable
DJ mixer
RCA cable
DJ mixer
RCA cable
DJS-2000
48
DJS-2000