Lcd-Display; Selecting A Track Via The Track-Buttons - Omnitronic DMS-1050 Bedienungsanleitung

6.2 CD-tray
Press Open/Close-button in order to open the disc tray. The CD-tray opens, the status-LED flashes and the
display shows "OPEN".
Insert your CD in the CD-tray. Make sure that you only hold the CD with 2 fingers on the edge. Avoid
touching the inside area of the CD.
CAUTION: Do not close the tray by pushing it as this could harm the construction.
Press the Open/Close-button again in order to close the tray. The status-LED flashes until the tray is closed.
The LED is turned off and the player is ready for operation.

6.3 LCD-display

If the CD is improperly positioned,"ERR" or "NO DISC" appears on the display.
If the CD is properly positioned, the CD-player reads the CD.
By pressing the SGL/CTN-button, the CD-player is put into Single-mode and the display shows "SINGLE".
The indication "0.0" means that the playback-speed has not been changed. If you adjust the playback-speed
via the Pitchfader (Pitch-LED of the selected speed is flashing), the respective percentage is indicated in the
display.
6.4 Play/Pause
In the Pause-mode the the time-indication in the display stands still and the Play/Pause-LED flashes. The
playback of the first track can be started by pressing the Play/Pause button. In the Playback-mode, the time-
indication in the display is running and the Play/Pause-LED shines permanently.
If you wish to interrupt the playback, press the Play/Pause-button and the laser stops at the position where
you stopped.

6.5 Selecting a track via the Track-buttons

You can select the desired track via the Track-buttons.
In order to play a track from the beginning, press the Track-buttons until the desired track number is
displayed. If you hold the respective Track-button, the CD-player will run through the track numbers until you
let the button loose.
«-button:
If you press the «-button once, playback starts at the beginning of the previous track. If a track is already
played back, you can start the current track from the beginning.
»-button:
If you press the »-button once, the playback starts at the beginning of the next track, if you press it twice the
following track, etc.
Please note that the CD-player calls the track up in the mode you pressed the Track-button. If the CD-player
is in the Play-mode at track 1 for example and you press the »-button, the player jumps to track 2 and
immediately starts playback.
The player jumps to the first track and is in the Pause-mode (Pause-symbol
flashes). Please note that the player automatically jumps to the section where
the music starts.
Next to "track" the track number is displayed. The track remain time is displayed
in M (MIN), S (SEC) and F (FRAME).
By using the Time-button, the time-indication can be switched from track remain
time (Remain) to total remain time (Total Remain) to track playback time
(Elapsed).
Above the time-indication, 10 bars are displayed showing the remaining track-
time visually. The shorter the track remain time becomes, the less bars are
displayed. 15 seconds before the track-end, the bars in the display start flashing.
25/56 10602425_V_1_0