Operation With Rls 5 Room Air Control; Displays, Operating Elements - Maico WRG 35 Montage- Und Betriebsanleitung

GB
6. Operation with RLS 5 Room air
control (surface- or recessed-
mounted version)
● The ventilation devices are operated using
the RLS 5 UP / AP room air control.
● WRG 35 devices in the standard version
and/or devices with humidity control are
adjustable.
● If several WRG devices are in operation, a
setting always affects all ventilation units.
● Up to 4 RLS 5 room air controls can be
networked in a ventilation system. Each
RLS 5 is given a device number (IP ad-
dress 1 to 4) during commissioning, which
is queried when the system starts up.
● Always operate WRG 35G devices as
master devices as the control only
evaluates and displays humidity values
from the master.
● Humidity alarm if relative humidity exceeds
80%. If this occurs, manually increase the
ventilation level.

6.1 Displays, operating elements

The graphical display shows
the weekday, the time and the
selected menu or function.
The starting image is for
example, automatic operation,
ventilation level 3.
● You can make system settings or select
menu items with the operating knob.
42
Graphical display
Operating knob with
identification light
● In the base state, the display is "off". The
operating knob is blue backlit.
● Press the operating knob to activate it.
After about 15 seconds without being
operated, the display switches off again.
● In the case of a fault, the operating knob
backlighting flashes red.
TURN the operating knob,
to the left or right:
Select menu item, change input value
or select button (graphical segment
bottom left/right).
PRESS operating knob: Confirms
the input/set value or activates the
selected function.
Always quit all menu settings with Exit.
i
The inputs are saved and the system
returns to the next higher menu level
or back to the starting image.
Input example Date & Time
The starting image appears on the graphical
display.
 Press and turn
 Press and turn
The Change field is marked.
 Press and set the year "YYYY" using
.
 Press and set the month "MM" using
.
 Press and set the day "DD" using
 Finished field appears. Press
 Mark the Continue field with
 Confirm with
described above.
 Mark the Exit field, press
 Turn to the right (each time until Exit)
and confirm the inputs until you get back to
the starting image.
until Settings.
until Time & Date.
.
.
and set the time as
.
.