Eurolite Ir-7 Remote Control (Optionally Available Accessories) - EuroLite LED SLS-90 Strobe SMD 5630 Bedienungsanleitung

EUROLITE IR-7 remote control (optionally available accessories)

1
2
3
4
Danger of explosion when battery is replaced improperly. Only replace by the same type.
Please dispose of old and used batteries properly. Batteries are hazardous waste and should
Button Function
BLACKOUT All LEDs on/off
AUTO Internal programs
SOUND Sound-controlled mode
MANUAL Manual color selection
% Dimmer
STROBE Strobe effect
The remote control is supplied with a battery inserted. An insulating foil between the
battery and the battery contacts prevents the battery from being discharged during
storage. Prior to the first operation remove the foil from the battery support on the
rear side of the remote control. Otherwise operation of the remote control is not
possible.
When actuating a button, always hold the remote control in the direction of the
sensor. There must be visual connection between the remote control and the sensor.
If the range of the remote control decreases (3 meters as a maximum), replace the
battery. For this purpose, on the rear side of the remote control press the small bar
with the groove to the right and at the same time remove the battery support.
For operation, one 3 V button cell type CR 2025 is
required. When inserting, pay attention that the positive
pole of the button cell shows upwards in the support.
not be disposed of with regular domestic waste!
-
Program 0-7 with +/–
Running speed with SPEED and +/–
Dimmer with % and +/–
Microphone sensitivity with SENSITIVITY and +/–
Dimmer with % and +/–
White brightness with W and +/-
Strobe effect with STROBE and +/–
Dimmer with % and +/–
Dimmer with % and +/–
Strobe effect with STROBE and +/–
CAUTION!
Setting options
27/34 00082676.DOC, Version 1.1