Operation; Control Board - EuroLite LED SLS-90 Strobe SMD 5630 Bedienungsanleitung

OPERATION

After you connected the LED SLS-90 Strobe SMD 5630 to the mains, it starts running.
The LED display lights up and you can choose the desired mode via the buttons MODE, ENTER, UP and
DOWN.
The device has three operating modes. It can be operated in Stand Alone Mode via the Control Board, via
optionally available EUROLITE IR-7 remote control or in DMX-controlled mode via every standard DMX
controller.
Please refer to the instructions under Control Board.

Control Board

The Control Board offers several features: you can simply set the starting address, run the pre-programmed
program or select a DMX channel mode.
MODE UP DOWN ENTER
No. Menu level 1
1 2 - C H
2 5 - C H
3 8 - C H
4 1 2 C H
5 P - -
6 S - -
7 U - -
8 S n d
9 S e n S
10 S E T
11 T e m p
Browse through the menu by pressing Mode. You can change the selection
by pressing Up or Down. Press Enter in order to confirm. You can leave
every mode by pressing Mode. The functions provided are listed in the
following sections.
Menu level 2 Menu level 3
d 1
d 5 1 2
d 1
d 5 1 2
d 1
d 5 1 2
d 1
d 5 1 2
P 0
P 1
P 2
P 3
P 4
P 5
P 6
P 7
S 1
S 1 0 0
d 0
d 2 5 5
S 0
S 2 5 5
u 0
u 1 0 0
O N
O F F
6 0
Description
Setting
DMX channel mode (Slave mode)
DMX address setting
Default setting: d 1
Internal programs (Master mode)
Default：P 0
Select the desired speed
S001 – S100 (increasing)
Default setting: S100
Dimmer intensity (Master mode)
000 – 255 (increasing)
Default setting：d255
Strobe effect (Master mode)
000 – 255 (increasing)
Default setting：S 0
Sound controlled mode (Master mode)
Microphone sensitivity
u000 – u100 (increasing)
Default setting：80
Control via IR remote
Default setting: On
Temperature
26/34 00082676.DOC, Version 1.1