After You Have Finished Using Your Appliance - Silvercrest IAN 292161 Bedienungsanleitung

3) To use the lid 9, place it on the part of the
housing which surrounds the attachment tool
socket 7 in such a way that the filling opening
is facing you . On the attachment tool socket 7
there is a locking device for the lid 9:
ATTENTiON! PrOPErTy dAmAgE!
► Never apply any pressure to the lid 9 when
attaching and removing it in order to ensure
that it is not damaged .
4) Depending on what you want to do, fit the
kneading hook 0, whisk q or beater w into
the attachment tool socket 7:
–
Insert the kneading hook 0, whisk q or
beater w into the socket 7 so that the two
metal pins on the axle of the attachment 0
q w lock into the recesses of the attach-
ment tool socket 7 .
–
Press the attachment 0 q w as far as it
will go into the socket 7 and then turn it
anticlockwise as far as it will go (in the
direction of the arrow
–
Let go of the attachment 0 q w . This is now
firmly held in the attachment tool socket 7 .
5) Add the ingredients you wish to process into
the mixing bowl 6 .
■ 6 │ GB │ IE │ NI
) .
NOTE
► Please note that during the kneading or stirring
process, the dough in the mixing bowl 6
increases in volume or is pressed upward
slightly as a result of the movement . You
should therefore never fill the mixing bowl 6
right up to the top!
Warning! Danger of crushing! Make sure
that no parts of the body are located
under the swivel arm 1 when you push it
downwards .
6) Press down the release lever 2 and press the
swivel arm 1 with the attachment mounted
downwards into the working position until the
swivel arm 1 locks in place .
NOTE
► If you wish, you can open the filling opening
8 on the lid 9 so that you can also fill in
ingredients during operation .
7) Turn the rotary switch 3 to the required level
(see the section "Speed settings") .
After you have finished using your
appliance
1) Turn the appliance off using the rotary switch 3
(Position "0") .
2) Press down the release lever 2 and move the
swivel arm 1 to the highest position .
3) Remove the attachment 0 q w from the
socket 7 by pressing the attachment 0 q w
lightly against the socket 7 and turning it
clockwise at the same time (in the direction
of the arrow ) . Then you can remove the
attachment 0 q w .
4) If fitted: remove the lid 9 .
5) Remove the mixing bowl 6 by turning it anti-
clockwise and then pulling it upwards .
6) Clean the appliance (see section "Cleaning
and care") .
SKV 1200 B2