Specific Safety Instructions - Dehn PHE Gebrauchsanleitung

1. Specific safety instructions
Only electrically skilled or instructed persons in accordance with EN 50110-1: ... (DIN VDE
0105-100:...) are allowed to use the PHE voltage detector – life hazard!
Only use the PHE voltage detector if fire and explosion protection measures were taken
(see B.2 and B.3 of EN 50110-1 (DIN VDE 0105-100: ...)).
The requirements on this voltage detector are based on the reduced values of the minimum
distances in accordance with DIN VDE 0101:... .
For this reason, the PHE voltage detector is only suitable to a limited extent for use in
factory assembled, type-tested installations (in accordance with DIN VDE 0670:...). The
user of the voltage detector or the operator of the switchgear installation must contact
the manufacturer of the factory assembled switchgear installation to find out whether
and where the voltage detector may be used.
Check that the PHE voltage detector is in good order and condition before it is used. If
there is damage or any other defect, the PHE voltage detector must not be used.
Only use the PHE voltage detector under the requirements and conditions referred to in
these instructions for use.
If only one of the safety instructions is not strictly followed or disregarded, life and health
of the user and system availability will be threatened.
Tampering with or modification of the PHE voltage detector or the installation of componen-
ts from other manufacturers or of other types will threaten occupational safety, are imper-
missible and will void warranty.
Page 3