Installing The Memory - Fujitsu D3348 Handbuch

Mainboard D3348

Installing the Memory

Before attempting to install any memory, make sure that the memory you have is compatible with the
motherboard as well as the processor. The D3348 board supports up to eight 288-pin 1.2 V / 2.5 V,
1600 /1866 / 2133 / 2400 MHz DDR4 modules.
Here are a few key points to note before installing memory into your D3348:
● The following memory modules are supported: 4 GB, 8 GB, 16 GB, 32 GB, 64 GB registered
and LR-DIMM ECC modules
● All installed memory will be automatically detected - no need to set any jumpers
● The D3348 supports up to 256 GB of memory
● Modules with different timing parameters can be installed on different slots within the same
channel, but only timings that support the slowest Module will be applied to all.
To reach maximal performance, plugging the modules in the following sequence:
2
1
LGA 2011
5 6
When two memory modules with a different number of ranks are populated in one memory
i
channel, then the module with the higher number of ranks must be populated in the
memory slot further away from the CPU.
If the system is upgraded and an additional memory module is added to a channel with an
existing module, it might be necessary to swap modules so that the module with the higher
number of ranks is populated on the outside (further away from the CPU) of that memory
channel.
Fujitsu
4
CPU
8
3
7
English - 25
61