1.3 WLANmaus: The Display Screen
All the functions of the WLANmaus can be checked on the large LCD with backlight. The symbols are as
follows:
Drive symbols
▪
Arrows shows the direction of
travel of the selected locomotive
▪
"II" denotes that the locomotive
is at a standstill (by controller or
selected emergency stop)
Battery symbol
▪
Not visible: Everything OK
▪
Visible: Battery/recharge-
able battery voltage drop
▪
Flashes: Replace batteries
Short circuit
▪
the symbol flashes in the
event of a short circuit
or an overload
Stop (stop-key)
▪
the symbol flashes
in the event of an
emergency stop or
short circuit
Shift-Symbol
▪
is shown as confir-
mation of the
-key
A completely depicted wireless symbol in the display indicates an optimal connection. The better the
connection, the more bars are displayed.
If the wireless connection is very bad, only the antenna symbol is depicted. If this is the case, it is
possible that the system will lose some of its functionality.
Should a radio link no longer exist between the WLANmaus and the WLAN router, the antenna
symbol flashes. No locomotive information (direction symbol, F-keys) is displayed.
Antenna symbol + flashing arrow/pause: WLAN connection ok, but no communication
+
with the Z21. Causes:
▪
▪
▪
8010813920.indd 41
Wrench
▪
the WLANmaus is in the
"Settings" menu level
▪
Menu level: Settings menu
ABC
▪
lights up when
text is being
entered
Z21 is not switched on.
Z21 is not correctly connected to the WLAN router.
Z21-IP nicht korrekt, (Z21 IP incorrect, see Part 3, Chapter 3.6.3, page 64).
MENU
Prog
▪
▪
the WLANmaus is
in the menu level
▪
Turnout symbol
(locomotive /turnout key)
▪
Turnout or route mode
▪
Menu level: Route menu
Wireless symbol
▪
This symbol provides infor-
mation about the wireless
connection
Locomotive symbol (locomo-
tive /turnout key)
▪
Driev- or turnout mode
▪
with MENu: "LOCO" menu
Light symbol (Light /OK key)
▪
locomotive light switched on
Function symbols ( 1 –10)
▪
display the currently
activated special locomotive
functions
▪
Menu level: submenus
lights up as a confirmation
when programming.
Menu level: programming
menu
13.07.2017 10:27:45
Basic
41