Features Of The Lokmaus; Plug And Play - Wiring The Lokmaus - roco Lokmaus 2 Handbuch

S
MART AND INTELLIGENT
The ROCO Lokmaus 2
designed and developed for digital beginners as well as for the advanced enthusiasts. It is the second
generation of the very successfull ROCO Lokmaus
guarantees you to get a system that fits the world-standard for two rails digital command controls
(DCC). The Lokmaus 2
if they are used by children can be easily protected against unintentional use. You take profit from a
Digital System that offers to you the most important features without the necessity to read a lot of
instructions and manuals.
GB
The factory-setup of the system allows you to control your layout by intuition because the system is
self-explaining – even the most important professional features. This manual tells you everything about
the advanced mode for the 'professional' players and model railroaders. We wish you happy hours with
your layout controlled by the Lokmaus 2
Warning: Using components of other manufacturers together with ROCO components you risc
damage or malfunctions. We approved a lot of components of other manufacturers that work
well. See the list at the end of this instruction.
F
EATURES OF THE
controls 99 loco-addresses
4
operates headlights and four additional functions
4
easy control of a loco by speed and direction by a knob
4
easy standard-programming-mode for address, minimum speed acceleration and deceleration
4
delay and maximum speed (CVs 1 to 5)
programming the CV29 with important settings for the operation of the loco
4
two digits LED display of the selected address or other information
4
14, 28 and 128 speed steps mode for all locos together or individually selectable for any loco
4
separately
emergency-stop that stops the complete layout and cuts current supply
4
autoconfiguration of the DataBUS address
4
the system koordinates 31 devices such as the ROCO Lokmaus 2
4
setup-menu to change a lot of system-features
4
protected mode (programming and emergency-stop can be switched off)
4
operates semaphores and switches if the decoder reacts to loco addresses
4
compatibility to the 'Lenz digital plus-System' and other NMRA-systems.
4
... and additionally in the professional mode:
easy programming of the CVs 1-99 with values from 0 to 99
4
big system of menus to setup the system's features and functions
4
using a more powerfull amplifier you can read out the decoders in the range from 01 to 99
4
... and additionally with the illuminated Lokmaus 2
indication of the sense of driving by illminating the arrow buttons
4
indication of switched functions ('F1' to 'F4') by illumination of the function buttons
4
menu prompt by illumination of the relevant buttons
4
P
LUG AND PLAY
The wire of the feeding track is plugged into the connector 'track out' of the amplifier. Then you connect
the two pole feeding wire of the amplifier to the two clamps of the transformer. Put the western-plug
22
— ROCO L
THE
resp. the PowerMouse™ is an ecenomy-priced digital control system. It was
®
offers to you two levels of operation. Functions that could cause problems
®
and reading this book.
®
L 2
®
OKMAUS
– L
WIRING THE OKMAUS
2 / P
®
OKMAUS OWER
. The compatibility to the standards of NMRA-DCC
®
the switch keyboard etc.
®
10790:
®
2
®
M ™
OUSE