Programming Help For Wlanmaus - roco Z21 Benutzerhandbuch

Appendix
The firmware update was unsuccessful or
was stopped: it is not possible to connect
the WLANmaus to the router.
4.3.1 Programming Help for Lokmaus 2 / R3 – WLANmaus
Previous operating manuals for digital ROCO articles (e.g. 42624 turnout drive) only describe the standard
programming mode for Lokmaus 2 /R3. The following includes a table which compares the programming
procedure for the Lokmaus 2 /R3 and quick programming (see chapter 2.6 on page 52) on the WLANmaus.
For more information see the operating manual for the Lokmaus 2 /R3. To program CV29 see the operating
instructions included with the decoder.
CV
1 – Adress
2 – Minimum speed
3 – Start-up delay
4 – Braking delay
5 – Maximum speed
29 – Decoder settings
Change speed steps
68
68
8010813920.indd 68
▪
While the WLANmaus is switched off, press the left ar-
row key, the "6" key and the "7" key at the same time
and keep them pressed down and then confirm this with
OK-key, in order to restart the original WLAN-
the
maus firmware. After the restart has taken place, the
ticker text "RESCuE FIRMWARE" appears in the display..
▪ Switch the WLANmaus off again, press and hold the
STOP-key, the "7" key and the "9" key at the same
time and then confirm this with the
thereby switching it back on again so that the origi-
nal radio module firmware can be restarted. After the
restart has taken place, the ver-sion number of the
rescue firmare appears in the display for one second
after the initial ticker text "WLANMAuS"
▪ After the restart has been carried out, your WLAN-
maus should again be in the delivery condition as far
as the software is concerned and it should then be
able to connect it with the router.
WLANmaus
+
+
+
+
+
Can only be programmed in
menu mode (see page 61)
+
/
OK-key, you
Lokmaus 2/R3 (for comparison)
+
+
+
+
+
+
+
/
13.07.2017 10:27:50