Gastroback VITAL MIXER Bedienungsanleitung Seite 34

WARNING:
If you process hot ingredients, please make sure not to burn yourself on
the blender jug or lid, or scald on steam or spraying liquids. Place perhaps a kitchen
towel over the lid to protect from splashes and steam.
Important: The motor will only operate when the blender jug is properly installed.
3. Keep one hand on the lid and turn the appliance on using the ON/OFF-switch. Be
sure to select the desired speed level. The motor starts to work.
ATTENTION:
If the motor ceases to operate unintentionally or is unusually slow, imme-
diately turn the ON/OFF-switch to position ›0‹. Otherwise, the motor may overheat.
Pay attention to the section ›Trouble Shooting‹.
Note:
If you have turned on the pulse function, the motor runs as long as you hold the switch.
4. After a few seconds turn the ON/OFF-switch to position ›0‹ (OFF) to turn off the
appliance.
5. Once the blades have come to a stop, grasp the blender jug by the handle and
remove the jug from the motor base. Afterwards you can remove the lid to check the
product or push solid or viscous ingredients with a wooden or plastic spoon down
gently.
If you wish to add other ingredients, use the beaker from the lid. To do this, turn the
beaker first anti-clock-wise and then pull it up and out. Put the ingredients through the
resulting hole and put the beaker afterwards back on.
You may possibly want to run the appliance once more for a few seconds until the pro-
duct has the desired texture. Return the blender jug onto the motor base. You can then
turn on the appliance again.
6. When the product has the desired consistency, turn the appliance off (ON/OFF-
switch to position ›0‹) and remove the blender jug from the appliance. Then remove
the lid from the blender jug. Flowable products - from drink to viscous dough - you
can pour from the blender jug. Then you can clean the blender jug immediately
according to the instructions.
IMPORTANT:
Do not leave to dry any food residues on the parts of the appliance. Cle-
an the equipment immediately after each use in accordance with the instructions ›Care
and cleaning‹.
34