Use; Ordering More Accessories - Cleanmaxx SLX225C Gebrauchsanleitung

2. Allow the battery of the device to charge up for around 10 – 14 hours in order to achieve
the maximum charging capacity. The control lamp lights up when the device is connected to
the mains power.
3. First disconnect the charger from the mains power and then disconnect the barrel connector
from the device.

Use

CAUTION!
❐ Ensure that there are no larger, sharp objects on the surface which is to be cleaned.
❐ Make sure that the MAX marking on the dust container is not exceeded when liquids are
sucked up.
❐ Always hold the device horizontally when liquids are sucked up. Make sure that sucked-up
liquids do not get into the motor unit.
❐ Empty and clean the dust container after each use (see the "Cleaning and Storage" chapter).
❐ Do not use the device when it is connected to the charger.
1. Remove the charger from the device.
2. Insert one of the attachments into the suction opening on the front of the collecting container.
3. Select an attachment. The attachments are inserted into the suction opening on the front
of the device:
Crevice nozzle:
Use the crevice nozzle to vacuum in folds in fabrics, corners, recesses or other places which
are hard to reach.
Crevice nozzle brush attachment:
Place the brush attachment onto the crevice nozzle. The crevice nozzle brush
attachment cannot be used without the crevice nozzle! Use the brush attachment
to remove dust from delicate objects such as picture frames, lamp shades, keyboards, books
etc.
Short nozzle:
Use the short nozzle to remove dirt and small quantities of liquid on smooth surfaces.
4. Switch on the device using the On / Off switch. The device will start vacuuming immediately.
5. Move the device over the area which is to be cleaned.
6. Switch off the device using the On / Off switch after you have fi nished vacuum cleaning.

Ordering More Accessories

If you want to order more original accessories, visit our website: www.service-shopping.de
19