Yamaha RX-V363 Bedienungsanleitung Seite 49

LFE/Bass out BASS OUT
Use this feature to select the speakers that output the LFE
(low-frequency effect) and the low-frequency signals.
Choices: SWFR, FRNT, BOTH
y
If you are not satisfied with the bass sounds from your speakers,
you can change these settings according to your preference.
When a subwoofer is connected to this unit
and you want to get natural bass sound
Select "SWFR" (subwoofer). The LFE signals as well
as the low-frequency signals of other speakers set to
"SML" (or "SMALL") are directed to the subwoofer.
When a subwoofer is connected to this unit
and you want to get rich bass sound
Select "BOTH" (both). The low-frequency signals of
any source are output from the subwoofer. The LFE
signals as well as the low-frequency signals of other
speakers set to "SML" (or "SMALL") are directed to
the subwoofer. The low-frequency signals of the front
left and right channels are directed to the front left and
right speakers and the subwoofer regardless of the
"FRONT" setting (see page 46).
When you do not use a subwoofer
Select "FRNT" (front). The LFE signals, the
low-frequency signals of the front left and right
channels, and the low-frequency signals of other
speakers set to "SML" (or "SMALL") are all directed
to the front left and right speakers regardless of the
"FRONT" setting (see page 46).
Crossover CROSSOVER
Use this feature to select a crossover frequency of all the
speakers set to "SML" (or "SMALL") or to "NONE" in
"SPEAKER SET" (see pages 45 and 46). All frequencies
below the selected frequency will be sent to the subwoofer
or to the speakers set to "LRG" (or "LARGE") in
"SPEAKER SET" (see pages 45 and 46).
Choices: 40Hz, 60Hz, 80Hz, 90Hz, 100Hz, 110Hz,
120Hz, 160Hz, 200Hz
Subwoofer phase SWFR PHASE
Use this feature to switch the phase of your subwoofer if
bass sounds are lacking or unclear.
Choices: NRM, REV
• Select "NRM" if you do not want to reverse the phase
of your subwoofer.
• Select "REV" to reverse the phase of your subwoofer.
■ Speaker level
B)SP LEVEL
Use this feature to manually adjust the output level of each
speaker.
Control range: –10 to +10 dB
Control step: 1 dB
Initial setting: 0 dB
SP LEVEL
FL
Front left speaker
FR
Front right speaker
C
Center speaker
SL
Surround left speaker
SR
Surround right speaker
SWFR
Subwoofer
Note
The available speaker channels differ depending on the setting of
the speakers.
Set menu
Adjusted speaker
47
En