Remote Control; Resetting The System - Yamaha RX-V363 Bedienungsanleitung

■ Remote control

Problem
The remote control
Wrong distance or angle.
does not work nor
function properly.
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
The batteries are weak.
Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control.

■ Resetting the system

Use this feature to reset all the parameters of this unit to
the initial factory settings.
Press A STANDBY/ON on the front panel to
1
set this unit to the standby mode.
Press and hold J TONE CONTROL and
2
then press A STANDBY/ON to turn on this
unit.
The advanced setup menu appears in the front panel
display.
Press K PROGRAM l / h to select
3
"PRESET".
Press L STRAIGHT repeatedly to select
4
"RESET".
Select "CANCEL" to cancel the initialization
procedure without making any changes.
Press A STANDBY/ON to confirm your
5
selection and set this unit to the standby
mode.
Cause
The remote control functions within a maximum
range of 6 m (20 ft) and no more than 30 degrees
off-axis from the front panel.
Reposition this unit.
Replace all batteries.
Notes
• This procedure completely resets all the parameters of this unit
including the set menu parameters. However, the advanced
setup menu parameters will not be initialized.
• The initial factory settings are activated next time you turn on
this unit.
y
To cancel the initialization procedure at any time without making
any changes, press L STRAIGHT repeatedly to select
"CANCEL" and then press A STANDBY/ON.
Troubleshooting
Remedy
See
page
21
—
3
57
En