Inserting Batteries In The Remote Control; Risk Of Damage; Connecting The Antenna; Connecting Power Supply - Medion LIFE P18072 Bedienungsanleitung

4.3. Inserting batteries in the remote control

 Remove the battery compartment cover on the back of the remote control.
 Insert two LR03 (AAA) 1.5 V batteries in the battery compartment of the remote control. Check the battery polarity
(inscribed on the bottom of the battery compartment).
 Close the battery compartment.
WARNING!

Risk of damage!

The remote control can be damaged by leaking batteries if not used for a long peri-
od of time.
 Remove the batteries from the remote control if the device is not going to be
used for a long period.

4.4. Connecting the antenna

Your smart TV supports different antenna signals.
You can feed the following image signals via the connection labelled ANT.:
• via analogue cable/an analogue house antenna,
1
• via a DVB-T antenna or
• via a DVB-C 1 connector (digital cable)
 Connect the antenna cable from either the house aerial/the analogue cable connection, the DVB-T antenna or the
DVB-C connection to the antenna connection on the smart TV.
You also have the option of connecting a digital satellite system to the connection labelled LNB.
 Screw the F connector of a coaxial antenna cable onto the connection on the smart TV.
PLEASE NOTE!
To receive encrypted/subscription channels you will need to use a CI module and an appropriate card. Insert
the CI module (available from dealers) in the appropriate slot on the left side of the device (Common Inter-
face). You can then insert the card from your provider into the CI module.

4.5. Connecting power supply

 Connect the mains plug on the device to an easily accessible 220 - 240 V ~ 50 Hz mains socket.
4.6. Switching the smart TV on and off
 Set the power switch on the lower side of the device to ON. The device switches to standby mode and the display
on the front will light up.
 To switch the device on, press
- on the remote control: the Standby/On button
- on the device: the MODE multifunction button.
 Use the Standby/On button
be switched off but continues to use power.
PLEASE NOTE!
If the device is not receiving an input signal, it will automatically switch to standby mode after five minutes.
A countdown timer will appear on the screen until this time. This function is not available for all sources.
1 This service must be available in your region.
, one of the number buttons or one of the P-/+ buttons;
on the remote control to switch the device back into standby mode. The device will
EN
15