Inserting The Batteries In The Remote Control; Risk Of Damage; Connecting The Antenna - Medion LIFE P15010 Kurzanleitung

3.3. Inserting the batteries in the remote control

 Remove the battery compartment cover on the back of the remote control.
 Insert two LR03 (AAA) 1.5 V batteries in the battery compartment of the remote
control. Check the battery polarity (see label on the bottom of the battery com-
partment).
 Close the battery compartment.
PLEASE NOTE!

Risk of damage!

The remote control can be damaged by leaking batter-
ies if not used for a long period of time!
 Remove the batteries from the remote control if the
device is not going to be used for a long period.

3.4. Connecting the antenna

Your LCD TV supports different antenna signals. You can input the following image
signals to the television through the socket labelled RF:
• Via analogue cable/an analogue house aerial
• Via a DVB-T/DVB-T2
1
• Via a DVB-C connection
 Insert the antenna cable either from the house aerial/analogue cable connec-
tion, a DVB-T antenna or the DVB-C connection in the antenna socket on the LCD
TV.
You also have the option of connecting a digital satellite system to the socket la-
belled LNB IN.
 Screw a coaxial antenna cable's F connector onto the connector on the LCD TV.
If you want to watch encrypted channels, or subscription channels, you
must use a suitable card. Insert a CAM module (available in specialist
shops) in the slot provided for this purpose on the left-hand side of the
device (COMMON INTERFACE). You can then insert your provider's card
in the CAM module.
This service must be available in your region
2
antenna or
EN
11