Mounting; Inserting Batteries In The Remote Control; Connecting The Antenna - Medion MD 31360 Kurzanleitung

3.2. Mounting

Attach the stand as shown in the illustration. Carry out this step before connecting the smart TV.
1
3

3.3. Inserting batteries in the remote control

 Loose the screw of the battery compartment cover on the back of the remote control and
remove the cover.
 Insert two LR03 (AAA) 1.5 V batteries in the battery compartment of the remote control. Check
the battery polarity (inscribed on the bottom of the battery compartment).
 Close the battery compartment by fixing the cover with the screw.
NOTICE!
Risk of damage!
The remote control can be damaged by leaking batteries if not used for a long
period of time!
 Remove the batteries from the remote control if the device is not going to be
used for a long period.

3.4. Connecting the antenna

Your smart TV supports different antenna signals.
You can feed the following picture signals via the connection labelled ANT.:
• via analogue cable/an analogue house antenna,
• via a DVB-T/ DVB-T 2
2
• via a DVB-C connector (digital cable)
 Connect the antenna cable from either the house aerial/the analogue cable connection, the
DVB-T antenna or the DVB-C connection to the antenna connection on the smart TV
2
This service must be available in your region.
4 x
2 antenna or
2
4
4 x
EN
9