Medion LIFE P18072 Bedienungsanleitung Seite 81

4.7.2. Cable
If you have previously activated the reception type DIGITAL CABLE, you can now make settings for the network
search. If it should be necessary, you can adjust the START FREQUENCY, the STOP FREQUENCY and the
SEARCH STEP correspondingly.
4.7.3. Satellite
If you have previously activated the reception type SATELLITE, you can now make settings for the antenna type.
 To set the antenna type, select one of the following antenna types:
− DIRECT: Select this antenna type if you have a single receiver and a satellite antenna. Press the OK button and
then choose the desired satellite (you can also call up the transponder list using the blue button). Afterwards,
press the OK button again to start the search. After that, decide whether or not the channellist should be load-
ed.
− SINGLE SATELLITE CABLE: Select this antenna type if you have multiple receivers and a single-cable sys-
tem. Press the OK button and make all the necessary settings regarding SATELLITE POSITION 1/2,
USER BAND and BAND FREQUENCY (here you can also call up the transponder list using the blue but-
ton). Afterwards, press the OK button again to start the search. After that, decide whether or not the channellist
should be loaded.
− DISEQC SWITCH: Select this antenna type if you have multiple satellite antennas and a DiSEqC switch. Press
the OK button and activate the desired DISEQC switch 1–4 (here you can also call up the corresponding
transponder list using the blue button). Afterwards, press the OK button again to start the search. After that,
decide whether or not the channellist should be loaded.
 Afterwards, press OK to continue.
18
Network channel scan - Digital Cable
Start Frequency
Stop Frequency
Search Step
Change Value
Continue
OK
First time installation
Antenna type
If you have a single receiver and a direct satellite dish,
select this antenna type.
Choose antenna type Continue
OK
114.00 MHz
858.00 MHz
8000
Back
MENU Exit
BACK
Direct
Back
BACK