SEW-Eurodrive Movifit MC MTA11A-503-S513-M01-00 Betriebsanleitung Seite 45

5.3.12 UL-compliant installation
HINWEIS
Das folgende Kapitel wird unabhängig von der Sprache der Ihnen vorliegenden
Druckschrift aufgrund von UL-Anforderungen immer in englischer Sprache abge-
druckt.
Field Wiring Power Terminals
Observe the following notes for UL-compliant installation:
•
•
Short Circuit Current Rating
Suitable for use on a circuit capable of delivering not more than 200,000 rms symmet-
rical amperes when protected as follows:
For 240 V systems:
250 V minimum, 25 A maximum, non-semiconductor fuses
or 250 V minimum, 25 A maximum, inverse time circuit breakers
For 500 V systems:
•
Branch Circuit Protection
Integral solid state short circuit protection does not provide branch circuit protection.
Branch circuit protection must be provided in accordance with the National Electrical
Code and any additional local codes.
For maximum branch circuit protection see table below.
Series
MOVIFIT
Motor Overload Protection
MOVIFIT
Device and Line Protection
MOVIFIT
provided with device protection and line protection.
Ambient Temperature
MOVIFIT
ted output current. To determine the output current rating at higher than 40 °C, the
output current should be derated 3.0 % per °C between 40 °C and 60 °C.
Use 75 °C copper wire only
®
MOVIFIT uses cage clamp terminals.
MOVIFIT ® -MC, max. voltage is limited to 500 V.
non-semiconductor fuses
® -MC 250 V/500 V minimum,
25 A maximum
® -MC is not provided with solid state motor overload protection or equivalent.
®
-MC: Units in connection with ABOXes MTA...-M14-.. or MTA...-M15-.. are
® -MC is suitable for an ambient temperature of 40 °C, max. 60 °C with dera-
Elektrische Installation
Installationsvorschriften (alle Ausführungen)
inverse time circuit breaker
250 V/500 V minimum,
25 A maximum
Betriebsanleitung – MOVIFIT
5
45
®
-MC