Start Operation; Configuration - GREISINGER GMH 5130 Betriebsanleitung

H82.0.01.6C-03

5 Start Operation

Connect sensors, turn device on via
After segment test
if standard measurement is selected
if fast measurement is selected
if peak value detection is selected
After that the device is ready for measuring.

6 Configuration

Some menu points depend on current device settings.
To change device settings, press "menu"
display: "SEt"). Pressing "menu"
referring parameters, which can be selected with key
The parameters can be changed with
Pressing "menu"
"enter"
finishes the configuration and returns to standard measuring operation.
Pressing "menu" and "store" at the same time for more than 2 seconds will reset the device
to factory defaults.
If no key is pressed for more than 2 minutes the configuration will be aborted. All changes
will not be saved!
Menu Parameter
Set Configuration: General configurations
Operating Manual GMH 5130
key.
the device displays some configuration:
changes between the menus points, pressing
or
again jumps back to the main configuration menu and saves the settings.
Value Description
or
Unit: Select measuring unit
Arrow to bar, Measuring value is displayed in corresponding unit, the selectable units
mbar ...
depend on connected sensor
Arrow to "user" Measuring value is displayed in freely adjustable user-unit
Unit "user": base unit
bar, mbar
Unit "user": decimal point setting (only if user-unit selected)
0000, 000.0,
... .0000"
Unit "user": multiplication factor
-19999...19999
Sea Level: Sea-level correction
oFF Sea-level correction off
on Sea-level correction on (p.r.t. 7.4)
-2000 ... 9999 Sea-level in [m]
Rate: Measuring rate
Slo Slow measuring rate (4 Hz filtered, low power consumption)
FASt Fast measuring rate, filtered (1000 Hz)
P.dEt Peak detection: fast measuring rate, unfiltered (1000 Hz)
_____________________________________________________
for 2 seconds. This will activate the configuration menu (main
.
.
_____________________________________________________________________________
jumps to the
page 7 of 14
**
**
**