Cleaning And Maintenance - EuroLite STW-300A Bedienungsanleitung

Warning: If installing on slippery surfaces, the legs must be secured with screws or nails via the
Loosen the crank handle lock nut and lift the crank handle into place. Tighten the lock nut.
Installation of the adapter
Attach an appropriate adapter or TV-pin (heavy) to the top end of the stand and fasten it with the handle at
the side.
Installation of the luminaires
Caution: The loads have to be installed in a balanced way.
Caution: The carrying capacity of the stand must never exceed 35 kg!
Install the fixtures on the crossbeam and always install a safety-rope that can hold at least 10 times the
weight of the fixture. You must only use safety-ropes with screw-on carabines. Pull the safety-rope through
the hole in the mounting-bracket and over the crossbeam. Insert the end in the carabine and tighten the
fixation screw.
Loosen the crank handle fixation screw. Crank the handle in clockwise rotations until the desired height is
reached. Make sure that the maximum lifting height is never exceeded. Replace the crank handle to its
original position. Tighten the fixation screw very well, if necessary with an appropriate tool. Check to make
sure all fixation screws are properly tightened.
The footstep enables the stand operator to check equipment hanging from the device.
Before taking into operation for the first time, the installation has to be approved by an expert!

CLEANING AND MAINTENANCE

The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
The standing stability of the stand has to be checked.
All carrying parts have to be inspected on damages or material fatigue.
All screws used for installing the devices or parts of the device have to be tighly connected and must not be
corroded.
1) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
2) Mechanically moved parts like axles, eyes and others must not show any traces of wearing (e.g. material
abrading or damages) and must not rotate with unbalances.
3) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments.
4) We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth. Never use alcohol
or solvents!
5) Maintenance and service operations are only to be carried out by authorized dealers.
6) Should you need any spare parts, please use genuine parts.
7) Should you have further questions, please contact your dealer.
provided holes!
DANGER TO LIFE!
13/14 60000840_V_1_2.DOC