Fuse Replacement; Troubleshooting; Hints On Disposal; Declaration Of Conformity - Klarstein 10031084 Anleitung

Push both side of the fuse capsule towards each other and twist it to
open the fuse capsule.
Remove the damaged 5A glass fuse from the capsule then replace a
new 5A glass fuse.
To close the fuse capsule aline the latch and groove then push in and
twist to lock the fuse capsule.
Problem
Fan will not start.
Fan excessively noisy. Check that all screws in fan assembly are tight and properly seated.
Fan wobbles.
Disposal and Declaration of Conformity
According to the European waste regulation 2012/19/EU this symbol on the product
or on its packaging indicates that this product may not be treated as household waste.
Instead it should be taken to the appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and human health, which
could otherwise be caused by inappropriate waste handling of this product. For more de-
tailled information about recycling of this product, please contact your local council or your
household waste disposial service.
Producer: Chal-Tec GmbH, Wallstraße 16, 10179 Berlin, Germany.
This product is conform to the following European Directives:
2014/30/EU (EMC)
2014/35/EU (LVD)
2011/65/EU (RoHS)
2012/206/EU (ErP)
19

Fuse Replacement

Troubleshooting

Possible Cause and Solution
Check fuse or circuit breaker and replace if necessary.
Turn off electrical power, check all wire connections.
Check to make sure the dip switches from the transmitter and receiver are set on
the same frequency.
Check to make sure mounting bracket is installed properly.
If the above mentioned remedies can't eliminate the wobble, use the clip from
balance pack to make sure the position. Stick the balancing weight on the opposite
side of the mark place.