Acoustic Signals; Before First Use - Electrolux GA55GLV220 Benutzerinformation

56 www.electrolux.com
• The option stays on until you deactivate
it. Press the multitab button, the related
indicator goes off.
If you stop to use the combi
detergent tablets, before you start to
use separately detergent, rinse aid
and dishwasher salt, do these steps:
1. Deactivate the multitab option.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the water
hardness in your area.
6. Adjust the released quantity of rinse
aid.

5.3 Acoustic signals

The acoustic signals operate in these
conditions:
• The programme is completed.
• The level of the water softener is adjus-
ted electronically.
• The appliance has a malfunction.
Factory setting: on. You can de-
activate the acoustic signals.
Deactivating the acoustic signals
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode. Refer to 'SET-
TING AND STARTING A PRO-
GRAMME'.
2. Press and hold buttons (4) and (5) at
the same time until the indicators of
buttons (3), (4), (5) and (6) flash.

6. BEFORE FIRST USE

1. Make sure that the set level of the wa-
ter softener agrees with the water
hardness in your area. If not, adjust
the water softener. Contact your local
water authority to know the water
hardness in your area.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
3. Press button (5),
• The indicators of buttons (3), (4) and
(6) go off.
• The indicator of button (5) continues
to flash.
• The display shows the setting of the
acoustic signals.
4. Press button (5) to change the setting.
5. Deactivate the appliance to confirm.
5.4 Setting the Time Beam
colour
Nine colours are available for this light
beam. You can change the colour or de-
activate it.
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to 'SET-
TING AND STARTING A PRO-
GRAMME'.
2. Press and hold buttons (4) and (5) at
the same time until the indicators of
buttons (3), (4), (5) and (6) flash.
3. Press button (6).
• The indicators of buttons (3), (4) and
(5) go off.
• The indicator of button (6) continues
to flash.
• The display shows a number and
the letter C. Each number is related
to a different colour (0C = Time
Beam deactivated).
4. Press button (6) again and again to
change the colour.
5. Deactivate the appliance to confirm.
4. Open the water tap.
5. Processing residues can stay in the
appliance. Start a programme to re-
move them. Do not use detergent and
do not load the baskets.
On
Off