Dometic MCA1225 Montageanleitung Und Bedienungsanleitung Seite 19

MCA1215 – MCA2440
• The device must be installed on a level and sufficiently sturdy surface.
• Do not install the device in the same area as the batteries.
• Do not install the device above batteries, because they can emit corrosive
sulphur fumes that will damage the device.
A
NOTICE!
Before drilling any holes, make sure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
For installation and mounting you will need the following tools:
• Pen for marking
• Drill bit set
• Drill
• Screwdriver
To secure the device in place you will need:
• Machine bolts (M4) with washers and self-locking nuts or
• self-tapping screws or wood screws.
Fasten the device as follows:
➤ Hold the device against the installation location.
➤ Mark the fastening points.
➤ Fasten the device with one screw through each hole in the holders.
EN
Installing the device
19