Causes And Rectification Of Faults - Caso Master P1 Original Bedienungsanleitung

17.2 Causes and rectification of faults

caso Master P1
In the event of a fault, an error code will appear in the display; it
describes the cause of the fault.
The following table assists in localizing and rectifying minor
faults.
Fault Possible Cause
--- ---- Waiting status
Abnormal supply
voltage.
E1/E2
Abnormal
E3/E4
temperature
Overheating
protection / Bad
E5/E6
hotplate heat
radiation
Overheating
protection /
E7/E8
Temperature sensor
failure
► If error messages continue to be displayed after an extended
waiting period or after restarting the appliance, then it must be
sent to Customer Service to be examined.
► If you are unable to solve the problem with the steps shown
above, please contact Customer Service.
► Place a suitable pot/pan
onto the induction
cooking field. The plate
will work as usual
► Make sure the appliance
is connected to the
voltage indicated
► Please inspect the pot
► Please restart after
hotplate has cooled down
► Please restart after
hotplate has cooled
down
Please note
Troubleshooting
To Rectify
57